Extreme Networks Px Series - Manual (Page 39)

Px Series Application Switch Installation and Configuration Guide 4-9
Configuring SNMP
To assign a VLAN tag to a service, use the following command:
config service vip <ip address> vlan <vlan_tag_number> port <number>
protocol [tcp|udp] [L4|L7] server-group-name <label>
Configuring SNMP
Any network manager running the Simple Network Management Protocol (SNMP) can
manage the switch, provided that the management information base (MIB) is installed
correctly on the management station. Each network manager provides its own user
interface to the management facilities. If you are not familiar with SNMP management,
refer to the following publication:
The Simple Book by Marshall T. Rose
ISBN 0-13-8121611-9
Published by Prentice Hall
Changes to SNMP settings are executed immediately, and do not require the
build command.
Table 4-4 describes how to configure SNMP settings for the application switch.
Table 4-4: SNMP Configuration Settings
Setting Description
System
contact
(optional) The system contact is a text field that identifies the person or persons
responsible for managing the application switch.
Syntax:
SummitPx1:15 # config snmp sysContact <string>
System name The system name is the name that you have assigned to this application
switch. The default is the model name of the switch (for example,
SummitPx1 ).
This value is also used to set the prompt for the command-line interface.
Syntax:
* SummitPx1:13 # config snmp sysName <string>
System
location
(optional) Use the system location field to enter an optional location for this application
switch.
Syntax:
* SummitPx1:14 # config snmp sysLocation <string>