Epson 850N - Manual (Page 109)

Using the Ethernet Card
6-7
7. Select the target node address from the Card Address list.
Make sure this address matches the one listed under Node
Number on the status sheet.
8. Click the Timers button and select the Job Based option.
Then click Close .
9. Click Next , then follow the instructions on the screen for
the DLC printer driver installation.
Configuring for OS/2
To use EPSON Net! to configure the card, you must have OS/2
Warp Connect or Server with NetBEUI or NetBIOS over
TCP/IP.
EPSON Net! for OS/2 provides the following programs:
NetBEUI
RPRINT3, RSTAT3—LPT redirection
REMPRT3, REMBEU, REMSTAT3—pipe support
TCP/IP
RPRINT, RSTAT—LPT redirection
REMPRT, REMSTAT—pipe support
Setting Up Redirection to the Printer
To redirect the workstation’s ports to your printer, print a
status sheet for the Ethernet card to obtain the card’s serial
number as described on page 6-3, then follow these steps:
1. Insert the EPSON Stylus COLOR 850N CD-ROM in
your workstation’s drive.
2. Open an OS/2 full screen command session.
basket-6.fm Page 7 Wednesday, May 13, 1998 4:37 PM