Enterasys Networks 700 - Manual (Page 57)

Managing the Module 2-37
The MultiSwitch 700 Device View
To access the Ethernet Configuration Window:
1. Select the port you wish to configure; the Port Menu will display.
2. Click Configuration. The Ethernet Configuration window, Figure 2-16 , opens.
Figure 2-17. The Ethernet Configuration Window
From this window you can manually set the operational mode of the port, or —
for 100Base-TX and 1000Base-SX/LX/CX interfaces — set the port to Auto
Negotiate so that the appropriate operational mode can be determined
automatically. The mode you set will determine the port’s speed, duplex mode,
and flow control.
TIP
If you select the Configuration option available for a standard Ethernet or FDDI interface,
or for a Fast Ethernet port on a first generation module, an entirely different window
displays; see
Configuring Standard Ethernet and FDDI Ports , page 2-30 , or
Configuring Fast Ethernet Ports on First Generation Modules , page 2-31 , for
information on configuring these ports.