Epson 9840 - Manual (Page 46)

I N T E R F AC E M O D E L 9 8 4 0 V E R 6 . 0 . 2
@123LE
Acknowledge:
@123 Limit Setup Command Canceled
Limit Reset Command (LiR)
The Limit Reset (LiR) command is used to manually reset a latching limit that has been
activated. The format is L(limit number)R.
Example:
@123L1R
Acknowledge:
@123 Reset Limit 1
System Options Command (O)
The system Options command has 8 subcommands that are used to view or set the
options that appear on the system options menu. Option View (OV) displays all the
settings in the system options menu, Option Printer (OP) is used to set the printer
baudrate, Option Auto ID (OI) is used to turn auto-identification of load cells on or off,
Option Auto Zero (OZ) is used to turn auto-zeroing of load on or off, Option Com Address
(OA) is used to change the communications address of the unit, Option Baudrate (OB) is
used to change the communications baudrate, Option Linefeed (OL) is used to turn the
auto line feed option on or off, and OE which is used to turn the end of transmission
character on or off. Each of these options is described below.
Option View Command (OV)
The Option View (OV) command returns a list of the current settings of all the system
options. The format is OV.
Example:
@123OV
Acknowledge:
@123 Printer Baud Rate is 9600
Auto Identify is off
Auto Zero Channel A is off
Auto Zero Channel B is off
Com Address is 123
Com Baud Rate is 9600
Com Line Feed is off
Retain Tare is off
Freeze Display is off
RS232 End of Transmission Character is off
Option Printer Baudrate Command (OP)
The Option Printer baudrate (OP) command is used to select the printer baudrate. The
format is OP(code) where the code is from the table shown at the right.
M O D E L 9 8 4 0 P G 4 5 P U B . 2 8 5 6 - 1 6