Eiki LC-SD15 - Manual (Page 48)

48
Maintenance and Cleaning
When the life of the projection lamp draws to an end, the LAMP
REPLACE indicator emits yellow light. If this indicator emits yellow light,
replace the lamp with a new one promptly.
Follow these steps to replace the lamp.
Lamp
Lamp Cover
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
● Model No. of your projector : LC-SD15
● Replacement Lamp Type No. : POA-LMP78
(Service Parts No. 610 317 7038)
For continued safety, replace with a lamp of the same
type. Do not drop the lamp or touch the glass bulb! The
glass can shatter and may cause injury. Allow the projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
POWER LAMP
REPLACE
WARNING This indicator emits yellow light
when the life of the projection
lamp draws to an end.
Top Control
CAUTION
Screw
Screw
Turn off the projector and unplug the AC power cord. Allow
the projector to cool for at least 45 minutes.
Loosen 2 screws of the lamp with a screwdriver and pull the
handle out to remove the lamp.
1
3
Replace the lamp with a new one and tighten the 2 screws
back into position. Make sure that the lamp is set properly.
Replace the lamp cover and tighten the screw. 4
Remove the screw with a screwdriver, and remove the lamp
cover. 2
Connect the AC power cord to the projector and turn on the
projector.
6 Reset the Lamp replacement counter.
See “Lamp Replacement Counter” on the next page.
5
Lamp Replacement
Handle
Screw
CAUTION