Emerson MICRO MOTION F-SERIES SENSOR - Manual (Page 4)

2 Sensor Installation: F-Series
Before You Begin
Specifications
Full product specifications can be found in the F-Series Product Data Sheet, which is available from the
Micro Motion web site at www.micromotion.com.
Definitions
The term MVD ™ transmitter refers to the following transmitter models:
• Models 1500, 1700, 2500, and 2700
• Models 3500 and 3700
The term high-temperature sensor refers to the following F-Series models:
• F025A and F025B
• F050A and F050B
• F100A or F100B
The term extreme high-temperature sensor refer to the following F-Series models:
• F025C and F025E
• F050C and F050E
• F100C and F100E
European installations
This Micro Motion product complies with all applicable European directives when properly installed in
accordance with the instructions in this manual. Refer to the EC declaration of conformity for directives that
apply to this product.
The EC declaration of conformity, with all applicable European directives, and the complete ATEX
Installation Drawings and Instructions are available on the internet at www.micromotion.com/atex or
through your local Micro Motion support center.
Information affixed to equipment that complies with the Pressure Equipment Directive can be found on the
internet at www.micromotion.com/library.
Installation options
The F-Series sensor makes up one part of a Coriolis flowmeter. The other part is a transmitter. F-Series
sensors are available with the following electronics interfaces:
• An integral core processor for connecting to a 4-wire remotely mounted transmitter or to a
user-supplied remote host (Figure 1).
• An integral Model 1700 or 2700 transmitter (Figure 2).
• A 9-wire junction box for connecting to a remotely mounted transmitter or a remotely mounted core
processor (Figure 3).
• An integrally mounted IFT9701 transmitter (Figure 4).
• High-temperature and extreme high-temperature models are equipped with a flexible conduit, on
which can be mounted a Model 1700/2700 transmitter, a core processor, or a junction box (Figure 5).