Appendix, 3 multi custom code – Humax COMBO-9000 User Manual
Page 76
Advertising
10. Appendix
GB75
User’s Manual
10.3 Multi Custom Code
If you are using more than two receivers that have the same custom code, reset the custom code of the
remote control as the following.
1. If you have other HUMAX receivers supporting the multi custom code, turn them off to prevent
change of the custom code.
2. Point the remote control towards the remote control sensor of the receiver.
3. Press
the
0 and OK button for 5 seconds.
4. Press
the
NUMERIC button (from 1 to 6) to select the mode.
5. The multi custom code setting is completed.
Note:
If the receiver does not operate, reset the custom code to another number (from 1 to 6).
.
Advertising