Home Automation OMNITOUCH 53A00-1 - Manual (Page 5)

3
INSTALLATION
1) Make the cutout for the touchscreen
Hold the template (Installation Template – 53A10-1) against the wall so the top edge is at
the appropriate height and parallel to the floor. Using a Punch, or similar instrument, punch
through the center of each tick mark (+) on the template.
Drill a 1/4" hole at each punch mark. Using a pencil, draw a line around the quadrant of
each hole as shown as shown. Carefully cut along the pencil line.
DO NOT OVERSIZE THIS CUTOUT!
Figure 1
2) Remove the faceplate
Remove the faceplate from the touchscreen by grasping the top and bottom edges of the
faceplate and carefully lifting it away from touchscreen backbox.
Note: After installation, the faceplate may be removed by placing a flat blade screwdriver in
one of the slots on the bottom of the faceplate and gently lifting to release the latch on the
respective side. Repeat by using the slot on the opposite side.
LATCH RELEASE SLOTS
FACEPLATE - BOTTOM VIEW
Figure 2