Home Automation OMNITOUCH 53A00-1 - Manual (Page 9)

7
b. Swing the touchscreen assembly in place and secure to backbox using screws that
were removed in Step 3.
Figure 8
8) Install the touchscreen faceplate
Before installing faceplate, remove the protective film from the LCD area of the
touchscreen. Fasten the faceplate onto the touchscreen by hanging the top of the faceplate
on the top edge of the touchscreen, then gently snapping the bottom onto the touchscreen.
REMOVING THE TOUCHSCREEN
After installation, if it is necessary to remove the touchscreen from the wall, turn retaining
flange screws 1 turn counterclockwise.
Note: Do not turn the retaining flange screws more than 1 full turn counterclockwise; otherwise
the retaining flange may fall off into the wall.