Home Automation OMNITOUCH 53A00-1 - Manual (Page 7)

5
c. Place the assembled unit into the cutout in the wall.
d. Turn the retaining flange screws clockwise until they are snug (do not over tighten).
WALL
Figure 5
5) Terminate the communications cable
a. When connecting the touchscreen directly to the HAI controller, use the supplied
8-position modular cable assembly. Attach the wires coming from the controller to
the supplied cable assembly using the supplied wire spice connectors.
b. When connecting the touchscreen to the HAI Touchscreen Hub, terminate the cable
with an 8-position modular connector (as if to make a standard network cable).
6) Connect the communications cable to the touchscreen
Insert the 8-position modular cable into the RJ-45 connector (J1) on the touchscreen, through
the cutout in the touchscreen backbox (see Figure 6).