Hi-Touch Imaging Technologies PHOTOSHUTTLE 640PS - Manual (Page 92)

91
8. Windows 2000 will verify such device as the USB interface device.
9. Windows 2000 will search for the driver of such device. The
message of “New Hardware Found – Searching for the Driver of
This Device” will appear. Please select “Yes”.
10. Then “Digital Signature is Not Found -Printer” will appear. Please
select “Yes”.
11. After the files is copied, then the installatin is completed.
Q7: How can I uninstall the Hi-Ti Digital Photo Printer driver in Windows 98
SE correctly?
A7: 1. Press "Start/Setup/Control panel/Add/Delete Program/Uninstall HiTi
PhotoShuttle(640PS). Press “Add or Delete".
2. The window for uninstalling the printer driver will appear. Press
“Start”.
3. The window for restarting the computer will appear. Press “Yes”.
Q8: How can I uninstall the Hi-Ti Digital Photo Printer driver in Windows Me
correctly?
A8: 1. Press "Start/Set Up/Control panel/Add-Delete Program/Uninstall
HiTi PhotoShuttle(640PS). Press “Add-Delete”.
2. The window for uninstalling the printer driver will appear. Press
“Start”.
3. The window for restarting the computer will appear. Press “Yes”.
Q9: How can I uninstall the Hi-Ti Digital Photo Printer driver in Windows
2000 correctly?
A9: 1. Press "Start/Set Up/Control panel/Add/Delete Program/Uninstall
HiTi PhotoShuttle(640PS). Press "Add/Delete".
2. The window of uninstalling the printer driver will appear. Press
“Start”.
3. The window of restarting the computer will appear. Press “Yes”.
Q10: How can I reinstall the Hi-Ti Digital Photo Printer Driver in Windows 98
SE, ME, or 2000?
A10: 1. Press "Start/Set Up/Control panel/Add/Delete Program/Uninstall
HiTi PhotoShuttle(640PS). Press "Add/Delete".
2. Reboot your computer.
3. Insert the driver CD into the CD-ROM drive, then the CD will run
automatically and show the brief introduction of installation. Please
install the driver according to the brief introduction.
4. If the CD does not run automatically, please execute the installation
program in the folder at the path “My Computer/CD-ROM Drive/
Autorun.exe”.
Q11: The computer and printer have been connected, but the USB is not
working, what should I do?
A11: 1. Check whether the printer is on .
2. Check whether the USB cable is too long (recommended length:
within 1.5 m) .
3. Check whether the USB cable meets the specification .