Dvr configuration 3, Front panel leds and controls, Dvr configuration – Honeywell HRDE4X4 User Manual
Page 21: Front panel, Front panel leds, Chapter 3, dvr configuration
Rev 3.01
11
Document 900.0399
08/08
3
DVR Configuration
This chapter explains:
•
Front panel LEDs and controls
•
Initial DVR setup
•
Configuring live and recording modes
•
Setting motion zones
•
Setting recording schedules
•
Setting system parameters
•
Configuring remote network control
•
Setting storage parameters
Note
Ensure that your DVR is completely installed and all components are
connected before proceeding.
Front Panel LEDs and Controls
shows the DVR front panel.
describes the operational LEDs.
describes the control buttons.
Figure 3-1
Front Panel
Table 3-1
Front Panel LEDs
LED
Function
POWER
ON indicates power is applied to the unit.
REC
ON indicates recording is enabled.
HDD
ON indicates the system is accessing the hard drive.
EVENT
ON indicates the sensor(s) has/have been triggered or motion is detected.
NETWORK
ON indicates a user is connected to the system through the RAS software.