Honeywell HRDE4X4 - Manual (Page 28)

Rev 3.01 18 Document 900.0399
08/08
Figure 3-7 System Setup Screen
Follow Table 3-6 to set global System parameters.
Table 3-6 System Setup Fields
Field Description
DVR ID Sets the name of the DVR.
Press SEL, use the LEFT and RIGHT arrow controls to navigate through
the position for each alphanumeric character. Use the UP and DOWN
arrow controls to change the selected character. Press SEL to save the
name.
DESCRIPTION Press SEL to view system information (System version, storage capacity,
IP address and MAC address).
LOAD SETUP
DEFAULT Select ON to reset the system to the factory default settings.
ADMIN
PASSWORD Sets the administrator password. After selecting this menu item, you are
prompted for your current password and then the new password. Follow
the prompts to change and confirm the new password. The default
password is 1111. Use the arrow controls to change the password:
UP = 1
RIGHT = 2
DOWN = 3
LEFT = 4
NETWORK
PASSWORD Sets the remote access password. You need to enter this password
when connecting to this DVR through the RAS program (see
page 42 ).
After selecting this menu item, you are prompted for your current
password (the default password is 1111) and then the new password.
Follow the prompts to change and confirm the new password.
Use the arrow controls to change the password as described in ADMIN
PASSWORD above.
DATE
FORMAT Sets the desired date and time display format. Options are:
YYYY/MM/DD YYYY-MM-DD
MM/DD/YYYY MM-DD-YYYY
DD/MM/YYYY DD-MM-YYYY