Honeywell HRDE4X4 - Manual (Page 33)

Rev 3.01 23 Document 900.0399
08/08
Setup for Sending E-Mail Alerts and Reports
To set your options for sending e-mail alerts, use the UP and DOWN controls to navigate
through the menu items. Change the value of the menu item using the LEFT and RIGHT
controls or by pressing SEL to manually change the entry.
Figure 3-11 Send E-mail Setup Screen
Table 3-9 describes the Sending E-mail options.
Note We recommend that users do not use their web-mail address (such as
Hotmail or Yahoo) as the e-mail accounts to which the HRDE4x4 sends
e-mails. Use your company e-mail system instead.
Storage Setup
To assign how your DVR acts when the hard drive is full, set the storage parameters in the
Storage Setup screen.
Table 3-9 Send E-mail Setup Fields
Field Description
IP
NOTIFICATION When enabled (ON), the DVR sends network information (IP address,
Gateway, Subnet mask) to the specified e-mail address when the
network information changes or when the system is rebooted.
EVENT ALARM When enabled (ON), the DVR sends a captured image (JPEG), the site
(channel) name, and the record type of the alarm that occurred to the
specified e-mail address when the record type is set to either Motion or
Sensor and the alarm is currently ON.
MAIL
ADDRESS Press SEL to enter the e-mail address to which the DVR sends the
e-mail. For example:
[email protected]
MAIL SERVER
NAME Press SEL to enter the mail server name to which the DVR sends
e-mails.
ID Press SEL to enter your e-mail account ID/user name.
PASSWORD Press SEL to enter your e-mail account password.
RETURN MAIL
ADDRESS Press SEL to enter the e-mail address for returning e-mails due to
delivery failure or delay.