Honeywell HRDE4X4 - Manual (Page 25)

Rev 3.01 15 Document 900.0399
08/08
Figure 3-4 Recording Mode Setup Screen
Follow Table 3-4 to set the Recording Mode parameters.
Table 3-4 Recording Mode Setup Fields
Field Description
RESOLUTION Sets the resolution to either
FULL
Screen or
QUAD
View.
CHANNEL Selects the channel (camera 1–4) to apply the settings in this table.
Changes you make immediately take effect with the selected channel.
FRAME RATE Sets the frame rate for the specified channel (choose from
OFF
or
1–30
fps).
Note The sum of the frame rate values from each channel cannot exceed the maximum
frame rates for a specific recording resolution. The total Maximum frame rate for
NTSC video are 120 fps (frames per second) for Quad and 30 fps for Full.
QUALITY Selects the recording quality for the specified channel. Options are:
NORMAL, HIGH, SUPER
RECORDING Assigns the recording mode for each channel. Options are:
CONTINUOUS
;
BY MOTION
;
BY SENSOR
(record based on sensor
inputs);
BY SCHEDULE
;
DISABLE
MOTION ZONE Selects motion sensing zones. Options are:
FULL ZONE
,
PARTIAL ZONE
Note If Partial Zone is selected (press SEL), the screen changes as
shown in Figure 3-5 .
MOTION
SENSITIVITY Sets the motion sensitivity for the specified channel, from:
1
to
9
(where 9 is the most sensitive setting)
SENSOR TYPE Sets the type of sensor for the specified channel (see SENSOR IN on
page 8 for connection information). Options are:
None
N/O
normal open (ground connected to the input starts recording)
N/C
normal closed (ground connected to the input stops recording)
PRE RECORD Enables/disables pre-event recording. Pre-event recording time is five
seconds and only intra-frames are recorded for pre-event recording.
POST EVENT
RECORD Sets post-event recording time duration for the specified channel
(choose from 2–30 seconds).