Husqvarna E20 - Manual (Page 19)

19
REVERSE SEWING
CHANGING SEWING DIRECTIONS
Reverse sewing is used for locking the end of seams and
where reinforcement is needed. At the end of seam, press
down the reverse sewing lever and touch the foot control
lightly. Sew a few reverse stitches. Release the lever and the
machine will sew forward again (A).
1. Stop the machine at the point where you wish to change
directions with the needle in the fabric.
2. Raise the presser foot and turn the fabric using the
needle as a turning point.
3. Lower the presser foot and start sewing in the new
direction.
REMOVING THE FABRIC
Turn the handwheel towards you to bring the thread take up
lever to its highest position. Raise the presser foot and draw
the fabric away from you.
CUTTING THE THREAD
Hold the threads behind the presser foot. Using both hands,
guide them to the slit at the rear of the presser bar and press
down to cut the thread. You can also use the thread cutter on
the side of the machine (B).