Husqvarna E20 - Manual (Page 29)

29
3-STEP ZIG-ZAG
Sewing on lace and elastic, darning, mending, reinforcing edges.
Set the machine as illustrated. Pattern selector on “E”.
Stitch width 3-5
Place patch in position. The stitch length can be shortened to
produce very close stitches. (1)
When mending tears, it is advisable to use a piece of backing fabric
to reinforce. The stitch density can be varied by adjusting the stitch
length. First sew over the center and then overlap on both sides.
Depending on the type of fabric and damage, sew between 3 and 5
rows. (2)
Sewing elastic
1. Place the elastic on the fabric.
2. As you sew, stretch the elastic both in the front and behind the
presser foot as shown in fi g. (3)
Joining fabric
The elastic stitch can be used to join two pieces of fabric together
and is very effective when sewing knitted fabrics. If nylon thread is
used, the stitch will not be visible.
1. Place the edges of the two pieces of fabric together and center
them under the presser foot.
2. Sew them together using the 3-step zigzag stitch taking care to
keep the two fabric edges close together as shown in fi g. (4)