Harbor Freight Tools CEN-TECH 98982 - Manual (Page 11)

Page 11 SKU 98982 For technical questions, please call 1-800-444-3353.
MAInTEnAnCE And
SERVICInG
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
TO PREVEnT
SERIOuS InjuRY
FROM ACCIdEnTAL
OPERATIOn:
Turn the Power Switch (15) of
the Scale to its “OFF” position
and unplug the unit’s Power
Cord (17) from its electrical
outlet before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVEnT SERIOuS
InjuRY FROM EQuIPMEnT
FAILuRE:
do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
BEFORE EACH USE: Inspect 1.
the general condition of the Scale.
Check for loose screws, misalignment
or binding of moving parts, cracked
or broken parts, Battery leakage, and
any other condition that may affect its
safe operation.
BATTERY REPLACEMENT:
2. A Bat-
tery that fails to accept a charge is
an indication the Battery should be
replaced. To replace the Battery:
FIGuRE F
BATTERY
(16)
• Unscrew and remove the six
Screws (18) located on the back
panel of the Display (1).
(See Figure F.)
Remove the front portion of the Dis-
•
play (1) to expose the Battery (16).
(See Figure F.)
Remove the old Battery (16) and
•
replace with a new Battery of the
same type. Then, re-attach the
front portion of the Display (1) to
the back portion of the Display and
secure using the six Screws (18).
(See Figure F.)
IMPORTANT: The old Battery (16)
•
must be recycled according to local
solid waste authority instructions.
AFTER USE: 3. Clean all external
surfaces of the Scale with soft, clean
cloth. Do not use solvents. Do not
immerse the Scale in liquid.
4. WARnInG! If the Power Cord
(17) is damaged, it must be re-
placed only by a qualified service
technician.