Heat & Glo Fireplace Soho24B 2137-900 - Manual (Page 35)

35 Heat & Glo • Soho24B • 2137-900 Rev. P • 8/12
Stone Placement: Soho24B D. Positioning Stones
For proper performance and safety, it is critical that the Black
Onyx stones are set up in accordance with these instructions.
As you are positioning the stones, make sure that no
stones are in the cross-hatched area shown between the
two arrows above. This is to ensure proper lighting and
avoid interference with the pilot fl ame.
Step 3. Place a single layer of stones over the burner area
inside of the tabs surrounding the burner and behind the
pilot shield.
Figure 12.1.
WARNING
BURNER AREA
Figure 12.4.
Step 4. Place the remaining stones over the basepan
taking care not to add more stones to the burner area.
Figure 12.5.
Delayed Ignition Risk
• Place stones according to instructions.
• Do NOT place stones in area in front of pilot
shield.
• Do NOT place stones in a position that they may
fall into area in front of pilot shield.
• Do NOT use any media other than the stones
supplied with this fi replace.
Fireplace will not function properly.
Delayed ignition may occur.
Figure 2.
Step 1. The included stone placement jig MUST be used
any time stones are placed on the burner to ensure that
none end up in the cross-hatched area noted in Figure 1.
PILOT SHIELD
JIG
Step 2. The stone placement jig is shipped in its proper
position. Remove the two screws securing the jig, making
sure the jig stays in the proper position. See Figure 3.
Figure 12.3.
2137-936C
WARNING! Choking Hazard! Keep stones out of reach
of children.