Harbor Freight Tools 46813 - Manual (Page 21)

OUTER BLADE WASHER (#15-I)
ARBOR SHAFT (#13-I)
BLADE NUT (#16-I)
10” SAW BLADE
(#14-I)
FIGURE R
3. Reach into the Saw Blade opening and remove the Blade Nut (part #16-I)) and
Outer Blade Washer (part #15-I). (See Figure R, and Assy. Diagram I.)
4. Place the 10" Saw Blade (part #14-I) on the Arbor Shaft (part #13-I)).
NOTE: Make sure the teeth of the 10" Saw Blade are pointing DOWN toward
the FRONT of the Saw Table. (See Figures R, S, and Assy. Diagram I.)
10” SAW BLADE (#14-I)
SAW TABLE (#17H)
(FRONT)
(SAW TEETH POINT DOWN TOWARD FRONT OF SAW TABLE)
FIGURE S
SKU 46813 PAGE 21
SAW TABLE (#17H)
5. Replace the Outer Blade Washer (part #15-I) and Blade Nut (part #16-I) securely
on the Arbor Shaft (part #13-I). NOTE: In order to keep the 10" Saw Blade from
turning during this assembly procedure, place a piece of scrap wood on the Saw
Table and against the back sides of the 10" Saw Blade teeth. Then while holding
the scrap wood firmly in place, wrench tighten the Blade Nut onto the Arbor Shaft
to secure the 10" Saw Blade. (See Figures R, S, and Assy. Diagram I.)