Harbor Freight Tools 46813 - Manual (Page 26)

Trouble Shooting Guide, (cont.)
Problem Cause Solution
Motor (#7F) is slow or weak. Voltage from source is low.
Windings are burned out or
open.
Power Switch (#8E) is
defective.
Circuit is overloaded with
appliances, lights, or other
electrically powered
equipment.
Request a voltage check from
local power company.
Have the Motor
checked/repaired.
Have the Power Switch
replaced.
Do not use other appliances or
electrically powered
equipment on the same circuit
when using the Table Saw.
Motor (#7F) overheats. Motor is overloaded.
Dull 10" Saw Blade (#14-I).
Sawdust inside Table Saw is
blocking airflow.
Request a voltage check from
the local power company.
Replace the 10" Saw Blade.
Clean out the Saw Base (#1G).
When ripping, the cut burns
the workpiece, or stalls the
Motor (#7F). 10" Saw Blade (#14-I) teeth
are dull.
Workpiece is warped.
Rip Fence (#10C) is not
parallel with the 10" Saw
Blade.
Sharpen or replace the 10"
Saw Blade.
Replace the workpiece.
Realign Rip Fence, and lock it
in position with the Rip Fence
Handle (#37C).
Miter Gauge (#4A) does not
move freely. Miter Gauge Assembly is dirty. Loosen the Miter Gauge Knob
(#2A), clean and lubricate the
Miter Gauge Rod (#10A).
Rip Fence (#10C) does not
move smoothly. Rip Fence is mounted
incorrectly. Remove, reposition Rip
Fence, and lock it in position
with the Rip Fence Handle
(#37C).
Bevel & Height Handles (#5G)
are hard to turn. Sawdust has collected on the
mechanisms inside the Base
(#1G). Clean and lubricate the
mechanisms inside the Base.
10" Saw Blade (#14-I) does
not lower when turning the
Height Handle (#5G). Bevel Lock Handle (#19-I) is
not fully released. Fully release the Bevel Lock
Handle.
Table Saw vibrates
excessively. Floor surface is uneven.
V-Belt (#40-I) is damaged.
10" Saw Blade (#14-I) is
damaged.
Loose Bolt, Screws, Nuts.
Readjust the Leveling Feet
(#1B).
Replace the V-Belt.
Replace the 10" Saw Blade.
Tighten all Hardware.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAMS IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE
IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 46813 PAGE 26