Harbor Freight Tools 46813 - Manual (Page 8)

FIGURE C
SKU 46813 PAGE 8
10" Table Saw Main Parts Components
Part Name / Part # Function
Front Rail (#7H),
Rear Rail (#3H) Provides support for the Rip Fence (#10C)
and large workpieces.
Left & Right Extension Tables
(#5H) Provides support for large workpieces (removable).
Miter Gauge Groove The Miter Gauge (#4A) slides in the grooves located
on both sides of the 10" Saw Blade (#14-I).
Blade Guard (#10D) Always keep the Blade Guard down over the
10" Saw Blade (#14-I) throughout the cutting process.
Riving Knife (#6D) Located directly behind the 10" Saw Blade (#14-I). Supports
the Blade Guard (#10D), and keeps cut edges from binding.
Anti-Kickback Pawl (#2D) Designed to catch and hold the workpiece to prevent injury
should kickback occur.
10" Saw Blade (#14-I) 10" Saw Blade is adjusted with Bevel Handle and Height
Handle (#5G) located on the side and front of Base (#1G).
Align-A-Cut Insert (#4H) May be marked to indicate location of sawcut on the workpiece.
Rip Fence (#10C) Guides the workpiece during the cutting process. Adjusts
for width of cut.
Scale (#6H) Located on the Front Rail (#7H). Use in combination with Rip
Fence (#10C) to determine precise measurements in rip cuts.
Switch (#8E) Located on the Front Rail (#7H). Provides power to the Table
Saw. Yellow Switch Key must be inserted into the Switch
before Table Saw can be operated. To lock Switch in "OFF"
position, remove Yellow Switch Key.
Fine Adjustment Knob (#30C) Located on the front of the Rip Fence (#10C). Use to make
fine adjustments to the desired Rip Fence measurement for
precise
cutting. Push in on the Knob and turn to position Rip Fence.
Rip Fence Handle (#37C) Lift Handle up to release Rip Fence.
Lower Handle to lock Rip Fence in place.
Bevel Handle (#5G) Located on right side of Base (#1G). Turn Handle to tilt the
10" Saw Blade (#14-I) for a bevel (angled) cut.
Bevel Scale (#10G) Located on front of Base (1G). Indicates exact angle
(0
° - 45 ° ) in which 10" Saw Blade may be positioned.
Height Handle (#5G) Located on front of Base (1G). Turn Handle to lower or raise
Height of 10" Saw Blade (#14-I). Maximum height adjustment:
3.35" at 0
°
. Also used when replacing 10" Saw Blade.
Leg (#4B) Provides support for Table Saw.
Long & Short Leg Braces
(#10B, #9B) Provides support for Legs (#4B).
Leveling Foot (#1B) Turn to level Table Saw on the floor surface.
Base (#1G) Cast iron construction. 15" wide x 19" deep.
Miter Gauge (4A) Aligns workpiece for a miter cut. Miter Scale Indicator (#6A)
shows exact angle (0
° -90 ° right or left) for a miter cut.