Humminbird 531906-1EN_A - Manual (Page 27)

Change the Temperature Source
To change the temperature source after the network has been configured,
open the Network Source Setup dialog box to change the temperature sources
at any time (see Select a Temperature Source). Network settings are saved
even after the unit is powered off.
• Temperature Graph (1100 Series™): Temperature Source 1 provides
the data for the temperature graph on the display. When the
temperature source is changed, the temperature graph displays a red
mark to show where the temperature source was changed.
NOTE: The Temperature Graph menu setting is not shared on the network. It is a
local menu setting.
• If the control head cannot detect the set temperature source, the
digital readout box will flash. If the digital readout box is blank, the
source has been lost. Open the Network Source Setup dialog box to
assign a temperature source to the digital readout box. See Select a
Temperature Source for details.
Temperature Graph
(Source: Temp. 1)
Temperature Graph
1100 Series™
Red marks
indicate where
the temperature
source changed.
21 Temperature Sources