Humminbird 531906-1EN_A - Manual (Page 30)

Select a GPS Source
When you power on the network for the first time, the control head will
automatically choose the connected or internal GPS receiver to provide data to
the control head. Use the instructions below to select a GPS source for your
control head.
Select a GPS Source
1. Open the Network Source Setup dialog box.
2. Select the GPS Tab: Press the RIGHT Cursor key until the tab is
selected.
3. Scroll: Press the DOWN or UP Cursor keys. The selected source is
highlighted in white.
4. Select: Press the RIGHT Cursor key. The check mark indicates that the
source is being used by the control head.
5. Save: Press the EXIT key twice to close the dialog box. Network
settings are saved even after the unit is powered off.
Local Setup: To use separate GPS receivers for each control head,
repeat steps 1 - 5 on each control head until you’ve set a GPS receiver
for each unit.
Shared Setup: To use the same GPS receiver with more than one
control head, repeat steps 1 - 5 on each control head and select the
same GPS receiver on all units.
Menu System: When you select a GPS source, the control head
updates with the corresponding menu options and views. If the GPS is
shared between control heads, it may take a moment for the data to
synchronize. See GPS and Sharing Waypoints Overview for more
information.
24 GPS Sources