HP LASERJET 9000MFC - Manual (Page 63)

6 Output devices 63
3000-sheet stapler/stacker
3000-sheet stapler/stacker
Paper handling features
l up to 3000 sheets A4- or Letter-size paper
l up to 1500 sheets of A3- or Ledger-size paper
l jobs are offset and stapled, if desired
Using the stapler
The 3000-sheet stapler/stacker can staple documents consisting of a minimum of two pages, and a maximum
of 50 pages of 75 g/m
2
(20 lb) paper or equivalent 5.5 mm (.22 inches). The pages must be 64 to 199 g/m
2
(17
to 53 lb) of all sizes suppor ted by the product.
Keep in mind these additional points:
l The stapler bin can hold up to 3000 sheets.
l Heavier media might have a stapling limit of fewer than 50 pages.
l If the job you want stapled consists of only one sheet, or if it consists of more than 50 sheets, the product
copies or prints the job to the bin. However it will not staple.
Selecting the stapler
You can usually select the stapler through your program or driver, although some options might be available
only through the driver. See “STAPLING DOCUMENTS” on page 51. Where and how you make selections
depends on your program or driver.
If you cannot select the stapler from the program or driver, select the stapler from the product control panel.
1 Touch Copy Settings.
2 Touch Corner or Edge, depending on where you want the documents stapled, and then touch OK.
Note The page icon on the right side of the control panel shows the position of the staple.
ENWW