Record setup, Configuring the recording behavior of your dvr, Figure 2-57 – Honeywell HREP4 User Manual
Page 64: Setup window, Figure 2-58, Recording setup window
64
Installation
RECORD SETUP
Click MENU
on the control panel.
The SETUP window appears.
Figure 2-57
SETUP Window
Click RECORD SETUP in the SETUP window.
The RECORDING window appears.
Figure 2-58
RECORDING Setup Window
Configuring the Recording Behavior of your DVR
Use the
to configure the settings on the RECORDING OPERATION window. See
SCHEDULE MODE
Select either DAILY (one schedule applies to every
day of the week) or WEEKLY (each day of the week
has its own schedule).
PRE EVENT
RECORDING TIME
When the DVR is not in continuous recording mode,
this setting determines the amount of time that is
always recorded before an event (motion detection,
alarm input, for example) occurs.
POST EVEN
RECORDING TIME
When the DVR is not in continuous recording mode,
this setting determines the amount of time that is
always recorded after an event (motion detection,
alarm input, for example) occurs.