Hitachi CDR-8130 - Manual (Page 12)

12
SPECIFICATIONS
GENERAL
Power Requirements DC Voltage +12V ±10% 1.0A
+5V ±5% 0.7A
Ripple +12V 300 mVpp (maximum)
+5V 150 mVpp (maximum)
Dimensions ( W x H x D ) 146 x 41.3 x 190 mm (Excluding front panel)
Front panel : 149.3 x 42.7 x 5 mm
Mass 0.95 kg
Operating & Storage Conditions
Temperature 5 - 45 °C (operating)
-30 - 60 °C (non-operating)
Relative humidity 15 - 85% RH (operating)
(non-condensing)
10 - 90% RH (non-operating)
(non-condensing)
PERFORMANCE
Disc Diameter 120 mm, 80 mm
Rotational speed 71.3 - 52.7 s
-1
(Approx. 4,200 - 3,200 rpm)
Capacity (1M=2
20
=1,048,576) 650 Mbytes (Mode 1)
742 Mbytes (Mode 2)
Conditions : 333,000 blocks (74 min.) for
recorded area
Record Side Single side
Sustained Data Transfer Rate 1,200 - 2,400 kbytes/s (Mode 1)
(1k=2
10
=1,024)
Access Time
Average (1 / 3 - Stroke) 90 ms (Typical) (Note 1)
Full Stroke 150 ms (Typical) (Note 2)
Notes :
1) Average of 100 access operations, between 15-min 00-s 00-block and 35-min
00-s 00-block, with latency.
2) Average of 100 access operations, between 00-min 02-s 00-block and 59-min
59-s 74-block, with latency.
AUDIO PERFORMANCE
Number of Channels 2
Output Level Line : 0.7 Vrms TYP. (47 kohms load)
Headphone : 0.6 Vrms TYP. (32 ohms load)
Output Terminal Line : 4-pin terminal (2.54 mm pitch)
Headphone out : ø3.5 mm Jack
RELIABILITY
Data Error Rate 10
-12
or less (Mode 1)*
10
-9
or less (Mode 2)*
* Raw error rate assumed to be 10
-3
or less.
INTERFACE ATAPI - BUS
40-pin non-shielded connector
Note
Design and specifications are subject to change without prior notice.
Hitachi has done everything possible to prevent the failure of the CDR-8130. However, it is not
absolutely free from failure. In case it should fail, Hitachi is not responsible for the results.