Hitachi CDR-8130 - Manual (Page 7)

7
1
2 4 6
3 5
Circuit Board
OR
(Default setting)
Device is
Master
Device is
Slave
Cable
Select
(9) ATAPI Interface Connector
ATAPI bus connection (40 pin)
(10) Power Supply Connector (DC Input)
For connecting the power supply cable.
1 2 3 4
+12V
GND
+5V
Circuit Board
INSTALLATION
WHAT YOU NEED
HARDWARE
- CD-ROM Drive - Interface card
- Interface cable - Power supply cable
- Mounting screws
HARDWARE OPTION
- Audio connecting cable - Sound Card
SOFTWARE
- CD-ROM device driver
NOTE
If you need a interface card or interface cable or CD-ROM device
driver, contact your dealer.
HARDWARE INSTALLATION
To install this CD-ROM drive in the host computer, refer to the instruction
manual of each host computer.
And to install the interface card in the host computer, refer to the instruction
manual of each host computer and each interface card.