Hitachi CDR-8130 - Manual (Page 9)

9
Disc label side
Push
Disc Tray
120 mm Disc
Disc label side
Push
Disc Tray
80 mm Disc
IMPORTANT
- Do not press the OPEN/CLOSE button while the host computer is accessing
the disc. It may caused an error.
- When not using the CD-ROM Drive, keep the Disc Tray closed. It will prevent
the entry of the dust and dirt, and reduce the requirements for disc and lens
cleaning
If you do not observe the following items, troubles, such as that the Disc Tray can
not be opened or can not be closed, may occur or it may cause damage to the
mechanism of the CD-ROM Drive.
- Never use a damaged, broken or deformed disc.
- Do not press down hard on the Disc Tray when opening and closing the Disc
Tray.
EMERGENCY EJECT PROCEDURE
Only in case of emergency:
If the Disc Tray does not open when the OPEN/CLOSE Button is pressed, make
sure that the power of the CD-ROM Drive is turned on and software lock function
has not been used. If the Disc Tray still will not open, the CD-ROM Drive’s
Manual Emergency Eject mechanism may be activated.
This should be used only in case of emergency.
REMOVAL PROCEDURE
1. Turn off the CD-ROM Drive and wait at least 15 seconds till the disc stops
rotating.
2. Insert the Eject bar (for example, a straightened paper clip) into the Manual
Emergency Eject Hole about 25 mm (1 inch).
3. Pull the Disc Tray
CAUTION