hussmann CR3HTO-HTB - Manual (Page 9)

Rev.1104
9
Timer Operation
Numbered product
keys above
correspond to
FC4H-Cinnabon
pans 1-7 below
(back of case)
1
2
6
7 3
5 4 1
2
3
4
Numbered product
keys above
correspond to
FC3H-Cinnabon
pans 1-4 below
(back of case)
©FAST key
NOTE: The colon will flash if the unit is in hours /
minutes mode and be on constant in minutes /
seconds mode.
• To enter programming from '--:--', press the
©(FAST.) key for three seconds. The display will
change to "PROG".
• To change a time, press the desired product / pan
number key. The display will change to the existing
set time. Press the up or down arrow keys to change
to the desired time. To change another key press
that product key and follow the same procedure.
• To exit programming mode, press the ©(FAST.) key
and the timer will return to the operating mode
'--:--'.
• To cancel a product /pan cycle, press and hold that
product key.
• To view the remaining time on a product key, press
the SCAN key. Continue to press the SCAN key to
toggle through all active times.
For Service Call 1-800-243-9271
Eletrical Specifications
13" x 9" Openings 13" x 5" CIRCUIT 1
LENGTH QTY. VOLTS PHASE Amps
3' 4 0 115 1Ш 7.3
4' 5 2 115 1Ш 9.3