Harley-Davidson POWER WHEELS 74370 - Manual (Page 17)

Assembly
17
• Loosen the screw in the sound box battery compartment
door using a Phillips screwdriver and open the battery
compartment.
• Insert three, size “AA” (LR6) alkaline batteries in the
sound box as indicated in the battery compartment.
Hint: For longest battery life, use only alkaline batteries.
• Close the battery compartment door and tighten the
screw using a Phillips screwdriver. Do not over-tighten.
Sound Box
Battery
Compartment
Battery
Compartment
Door
31
SHOWN ACTUAL SIZE
1.5V x 3
“AA” (LR6)
TM
• Position the vehicle upright.
• Fit the tabs on the front fork cover into the rectangular
openings in the top of the front fork and push firmly
to snap the cover to the front fork.
Rectangular
Openings
Front Fork Cover
Tab
Tab
30
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the sound box.
Battery leakage and corrosion can cause damage.
Dispose of batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in these instructions are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
sound box before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
• When sound from the vehicle becomes faint, or if the
sound stops working, it’s time to replace the batteries.
Round
Bushing
• Fit a round bushing, plate side first, between the wheel
and the shock.
Helpful Hint: You may need to push the shock outward
slightly to fit the round bushing.
• Continue to slide the wheel axle through the round
bushing and then the shock.
• Fit a .437 (large diameter) retainer on the end of the
wheel axle.
• Support the opposite end of the wheel axle and tap the
retainer with a hammer to secure it on the end of the
wheel axle.
• Pull on the .437 retainer to make sure the front wheel
assembly is secure.
Shock
.437 (Large
Diameter)
Retainer
Wheel
Axle
29
Round Bushing
Plate Side