HandHeld Entertainment Document Reader 4800dr - Manual (Page 105)

4800dr Barcode Guide 10 - 3
Trigger Commands
You can activate and deactivate the document reader with serial trigger commands. First, the document reader must be put in
Manual/Serial Trigger Mode either by scanning the Manual/Serial Trigger Mode barcode ( page 3-3 ), or by sending the Manual/
Serial Menu Command ( page 10-6 ). Once the document reader is in serial trigger mode, the trigger is activated and deacti-
vated by sending the following commands:
Activate: SYN T CR
Deactivate: SYN U CR
The document reader scans until a barcode has been read, until the deactivate command is sent, or until the serial time-out has
been reached (see "Read Time-Out" on page 3-3 for a description, and the serial command on page 10-6 ).
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your document reader, or you’ve changed some options and want the factory
settings restored, scan the Standard Product Default Settings barcode below.
The chart on the following pages lists the factory default settings for each of the menu commands (indicated by an asterisk (*)
on the programming pages).
Menu Commands
Note: Not all menu commands apply to all document reader models.
Selection
Setting
* Indicates default
Serial
Command
# Indicates a
numeric entry
Page
Factory Default Settings Default DEFALT 10-3
Terminal Interfaces
Terminal ID *130 - USB COM Port Emulation
000 - TTL-232
124 - USB PC Keyboard
125 - USB Mac Keyboard
131 - USB HID POS
TERMID###
1-3
Standard Product Default Settings