HandHeld Entertainment Document Reader 4800dr - Manual (Page 34)

3 - 12 4800dr Barcode Guide
2. Code I.D.
On the Symbology Chart on page A-1, find the symbology to which you want to apply the output sequence format. Locate
the Hex value for that symbology and scan the 2 digit hex value from the Programming Chart (inside back cover).
3. Length
Specify what length (up to 9999 characters) of data output will be acceptable for this symbology. Scan the four digit data
length from the Programming Chart. (Note: 50 characters is entered as 0050. 9999 is a universal number, indicating all
lengths.) When calculating the length, you must count any programmed prefixes, suffixes, or formatted characters as part of
the length (unless using 9999).
4. Character Match Sequences
On the ASCII Conversion Chart (Code Page 1252) , page A-3, find the Hex value that represents the character(s) you want
to match. Use the Programming Chart to read the alphanumeric combination that represents the ASCII characters. (99 is
the Universal number, indicating all characters.)
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or Save to save your entries.
Other Programming Selections
•Discard
This exits without saving any Output Sequence changes.
Output Sequence Examples
In this example, you are scanning Code 93, Code 128, and Code 39 barcodes, but you want the document reader to output Code
39 1st, Code 128 2nd, and Code 93 3rd, as shown below.
Note: Code 93 must be enabled to use this example.
You would set up the sequence editor with the following command line:
SEQBLK62999941FF6A999942FF69999943FF
The breakdown of the command line is shown below:
SEQBLK sequence editor start command
62
code identifier for Code 39
9999 code length that must match for Code 39, 9999 = all lengths
41 start character match for Code 39, 41h = “A”
FF termination string for first code
6A code identifier for Code 128
9999 code length that must match for Code 128, 9999 = all lengths
42 start character match for Code 128, 42h = “B”
FF termination string for second code
69 code identifier for Code 93
9999 code length that must match for Code 93, 9999 = all lengths
43 start character match for Code 93, 43h = “C”
FF termination string for third code
A - Code 39
B - Code 128
C - Code 93