HandHeld Entertainment Document Reader 4800dr - Manual (Page 65)

4800dr Barcode Guide 6 - 17
UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of the scanned data or not. Default = On.
UPC-E0 Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the scanned data, but the unit can be
programmed so it will not transmit it. Default = On.
UPC-E0 Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-E data.
Default = Off for both 2 Digit and 5 Digit Addenda.
UPC-E1
Most U.P.C. barcodes lead with the 0 number system. For these codes, use UPC-E0 (page 6-16). If you need to read codes
that lead with the 1 number system, use the UPC-E1 selection. Default = Off.
Off
* On
Off
* On
* 5 Digit Addenda Off
5 Digit Addenda On
* 2 Digit Addenda Off
2 Digit Addenda On
UPC-E1 On
* UPC-E1 Off