HP 100VG-ANYLAN B5426-90001 - Manual (Page 13)

13
1 Installation Procedure
This section contains installation instructions for the HP-PB
100VG-AnyLAN Network Adapter. The instructions are organized into
six primary steps listed below. Each step is described in detail in this
section. If the adapter has already been installed at the factory, you may
proceed directly to step 4.
1. Prepare to install the adapter.
2. Shut down the operating system and switch off the computer.
3. Install the adapter.
4. Attach the adapter to the network.
5. Configure the adapter into the system.
6. Verify operation.