HP 100VG-ANYLAN B5426-90001 - Manual (Page 20)

20 Chapter 1
Installation Procedure
4. Attach the Adapter to the Network
4. Attach the Adapter to the Network
Use the RJ-45 connector for connecting a UTP category 3 or 5 cable
(not supplied) to a 100VG-AnyLAN hub or 10Base-T hub/switch. Refer to
Figure 1-3..
Figure 1-3 Port Connection
Attach the cable to the RJ-45 connector by following these steps:
a. Plug the cable into the RJ-45 connector.
b. Secure the other end of the cable to the 100VG-AnyLAN hub or
10Base-T hub/switch.
c. If necessary, reconfigure the hub/switch port to operate at the desired
speed and duplex settings.
NOTE All of the LEDs on the adapter (except the Power LED) are initialized by
software when the link is started on the system. Therefore, until
software initializes the adapter, the state of the LEDs cannot be reliably
interpreted.