HP 100VG-ANYLAN B5426-90001 - Manual (Page 18)

18 Chapter 1
Installation Procedure
3. Install the Adapter
3. Install the Adapter
To install the adapter in the host computer, perform the following steps:
a. Access the adapter slot(s).
b. Select an available adapter slot.
c. Insert the adapter into the slot.
d. Switch on the power to the computer.
a. Access the adapter slot(s)
Because computer models vary, there may be different procedures to
access and select an adapter slot. Before you install the adapter, you
should refer to the manuals that apply to your particular computer for
instructions. Identify the following information:
• authorized or recommended adapter configurations and limitations,
if any
• how to access the computer’s adapter slot(s)
• proper orientation of the adapter in its slot
b. Select an available slot
Select an available HP-PB adapter slot. Remove the slot cover for that
slot. Refer to your computer system administrator’s documentation.
Retain the cover for possible future use.
Verify you can see an adapter connector at the back of the slot.
Record the slot number for future reference. If there are no other
adapters to install, reassemble the computer.
c. Insert the adapter into the slot
Insert the adapter into the adapter slot connector and press in firmly
until the adapter is fully seated into the connector. Refer to Figure 1-2.
1. With both hands, grasp the adapter by its edges or faceplate. Do not
touch electronic components or electrical traces.