Heath Zenith 598-1135-08 - Manual (Page 6)

6 598-1135-08
Maximum
Coverage Angle
Maximum Range
Indoor Motion Sensor Coverage Area
Motion Sensor Controls
30 ft.
(9.1 m)
150°
5 1 TEST
ON-TIME
(MINUTES)
RANGE
MAX MIN
CODE
1 2 3 4
ON
5 1 TEST
ON-TIME
(MINUTES)
MIN MAX
DETECT RANGE
DAY
NIGHT
NIGHT
ONLY
Range Control
LED
Indicator
ON-TIME Control
Outdoor Motion Sensor
Indoor Motion Sensor
Indoor and Outdoor Motion Sensor Sensitivity
The detector is most sensitive to motion across its field of view.
Motion
Most Sensitive Least Sensitive
Motion
Sensor Sensor
aim Sensor down
for Short Coverage
aim Sensor Higher
for Long Coverage
Adjusting Indoor Motion Sensor Coverage
Maximum
Coverage Angle
Maximum Range
Outdoor Motion Sensor Coverage Area
70 ft.
(21 m)
8 ft.
(2. m)
180°
aim Sensor down
for Short Coverage
aim Sensor Higher
for Long Coverage
Adjusting Outdoor Motion Sensor Coverage
3. Adjust RANGE Control. To increase sensitivity, turn the RANGE
control toward MAX. To decrease sensitivity, turn the RANGE
control toward MIN. Note: If the RANGE is set too high, false
triggering may result in some environments.
Note: When using test mode to check operation in the day time:
A. Set the DETECT control switch to DAY/NIGHT and
B. Set the ON-TIME control to TEST.
. Set ON-TIME Control. Determine the amount of time you want
the connected device to stay on after motion is detected (1 or
5 minutes). Slide the ON-TIME control to the corresponding
setting.
IMPORTANT: Avoid Aiming Control At:
• Objects that change temperature rapidly, such as heating vents,
fans, and air conditioners. These air sources could cause false
triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light colored objects reflecting light may trigger the
shut-off feature. Do not point other lights at the sensor.