Heath Zenith 598-1135-08 - Manual (Page 9)

9 598-1135-08
ENGLISH
Figure 3 - Installing 3-Way Wall Switch
(Transmitter Shown)
DIM
ON/OFF
Button
Green Ground Wire From Switch
Wall Switch
Screw
Junction
Box
Wall
Switch
DIM
Button
Wall
Power
Disconnect
Switch
Wall Plate
Wall
Plate
Screw
Green (or Bare) Ground Wire
Black Wire
Red Wire
(Typical)
operation
1. Verify the power disconnect switch on the transmitter and
receiver is in the ON (right side) position.
2. Push the ON (top) button and release. The light should turn on
full bright. Note: If you are controlling a lamp, make sure it is
connected to the switched outlet and the lamp is switched on.
3. Push the OFF (bottom) button and release. The light should
turn off.
. Push the DIM button and release. The light should turn on at
50% brightness (or last setting). Note: Receiver remembers
the last DIM setting used. To recall last DIM setting, push and
release the DIM button.
5. Continue to press the DIM button until the desired dim level is
reached. Note: There are 5 DIM settings ranging from 15% to
90% brightness.
Note: The DIM setting defaults to 50% in the event of a power
failure.
IMpORTANT: Wait 1 to 2 seconds after you press a transmitter
button before you press it again to allow the transmission to be
completed.
Note: If light does not turn on or intermittently turns on and off when
transmitter buttons are pushed, see Troubleshooting Guide.
Bulb Replacement
Move the power disconnect switch on the transmitter and receiver to the
OFF (left side) position. Replace bulb(s). Note: The power disconnect
switch on the transmitter prevents the unit from sending any signals
to the receiver. The power disconnect switch on the receiver prevents
it from applying power to the load that it controls.
9. Position the wall switch transmitter in the junction box with the
DIM button located to the right. Use the two wall switch screws
(long) supplied to mount the transmitter to the junction box (see
Figure 3). Push excess wiring into junction box while you do
this, bending the wires to fit if necessary.
10. Mount the wall plate to the wall switch transmitter with the
screws (short) provided.
11. To install the wall switch receiver, repeat steps 5 through 10
above. Note: Route antenna between the bottom of the junction
box and the wall. Feed antenna into wall cavity while placing
wall switch into junction box.
IMPORTANT: Label wires on existing 3-way switch according
to the diagram in Figure 1. Refer to Figure 2 below when con-
necting wall switch receiver wires to existing wires.
12. Turn on the power to the light switch circuit. Do this at your circuit
breaker or fuse box. Note: If the light turns on immediately and
remains on, reverse the travel wire connections on
one of the
switches.
Travel Wires
TO HOT
OR LIGHT
TO HOT
OR LIGHT
TO HOT
OR LIGHT
1
BLACK
3
BLACK
GREEN (Ground)
DIM
1
BLACK
TO HOT
OR LIGHT
4
BLACK
GREEN
(Ground)
2 RED
2
RED
3 BLACK
4 BLACK
Figure 2 - Wiring 3-Way Wall Switch
Transmitter Receiver