HP 2103R-CSDI - Manual (Page 37)

Installing the ONcore Edge Router Module 2-13
4 Using your fingers, tighten the two spring-loaded screws on the front of the
module faceplate (Figure 2-4). Do not overtighten.
Figure 2-4 Installing the Edge Router Module in an ONline Hub
Installing the
ONcore Edge
Router Module
You do not need to power off the ONcore hub to install or remove the
Edge Router module. You can insert the module while the hub is operating
(this is called a hot swap).
To install the Edge Router module in an ONcore hub:
1 Use one of the following proper grounding techniques when you install the
Edge Router module:
■
Properly ground yourself prior to handling the module.
■
Attach a static wrist guard to yourself or touch a grounded static mat
prior to handling the module.
If you already have a management terminal connected to your ONcore hub,
you can verify the hub has enough power for the new Edge Router module
by entering the SHOW POWER BUDGET command. Refer to Appendix A for
details on power requirements.
Refer to the ONcore Distributed Management Module Commands Guide for
information on the SHOW POWER BUDGET command.
2 Locate an open slot in the ONcore hub. If necessary, remove a blank panel
to expose a slot.
Screws
Faceplate
Board guide
Board guide
Hub backplane