HP 2103R-CSDI - Manual (Page 55)

Showing Module Configuration and Status 4-3
Each LED is described in Table 4-1.
Showing Module
Configuration
and Status
This section describes NMM commands that show module configuration
and status.
To show configuration and status for an Edge Router module, use the
following network management module commands:
■
SHOW MODULE
■
SHOW PORT
Table 4-1 Module LED Interpretations
LED Name Color State Indicates
S
(Module Status)
Green Blinking The module is in boot mode
and is attempting
communication with the
carrier board.
On Remains lit as long as there
is active communication
with the carrier board.
RTR
(Router Status)
Green On Router is functioning
properly.
Off or Blinking Router is not functioning.
Replace the module.
E0 Activity
(Ethernet Activity)
Yellow Blinking Traffic is being passed.
S0
(Serial Port 0 Activity)
Yellow Blinking Traffic is being passed on
serial port 0.
S1
(Serial Port 1 Activity)
Yellow Blinking Traffic is being passed on
serial port 1.