Heath Zenith 3003530 - Manual (Page 6)

-6- 598-1073-03
123

5678
1
2
3

5
6
7
8
* Code Settings 1-7
Must Match Both
Sensor and Chime
Inside
Sensor
Remove
screw to open
access door
Back of Chime
. To change the code, either:
• Add a jumper to the same location on both the sensor and the chime
or...
• Remove a jumper from the same location on both the sensor and the
chime or...
• Move a jumper on the sensor from one location to another. Move the corre-
sponding jumper on the chime to match the new location in the sensor.
Example: Move jumper at location “5” to location “” on both the sensor
and the chime.
Note: Jumpers in positions 1 through 7 must be exactly the same for both
the sensor and chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the
sensor and on the chime.
The range of the wireless chime can vary with location, temperature, and
battery condition.
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
ACE ® reserves the right to discontinue and to change specifications at any time without notice
without incurring any obligation to incorporate new features in previously sold products.