Henny Penny OEA - Manual (Page 3)

Model OFE/OFG/OEA/OGA-341, 342
3-2. OPERATING CONTROLS This section provides operating procedures for the Henny
12 BUTTON CONTROLS Penny 340 series open fryer with 12 button timer controls.
Read sections 1, 2, and 3, and all instructions before
operating the fryer.
Figure 3-2 shows the function of the 12 button timer control.
Fig.
Item Description Function
No. No.
3-2
1 This LED lights when the control calls for heat,
and the burners come on and heat the shortening
3-2
2 Digital Display Shows the shortening temperature, the timer countdown in
the Cook Cycle, and the selections in the Program Mode;
press the INFO button to display the temperature of the
shortening; if the temperature exceeds 425 °F (218°C), the
display reads "E-5", “FRYER TOO HOT”
3-2
3 Once the fryer is out of the Melt Mode, this LED
lights, signaling the operator that the shortening temperature
is not at the proper temperature for cooking product
3-2 4 This LED lights when the shortening temperature is within 5 °
of the setpoint temperature, signaling the operator that the
shortening temperature is at the proper temperature for
cooking product
3-2
5 Used to display the current shortening temperature, the
setpoint temperature, as well as cooking performance, and
other information such as, filter use, time of day, etc; in the
Program Mode, it steps back to the previous parameter
3-2 6 & 7 Used to adjust the value of the currently displayed setting
in the Program Mode
903
3-3