Harbor Freight Tools CHICAGO 96325 - Manual (Page 10)

Page 10 SKU 96325 for technical questions, please call 1-800-444-3353.
Place the Vacuum Assembly onto the top of the Canister, catch the edge of the
Canister with the Latches, and move the Latches upward to secure. The Vacuum
Assembly mechanism is located at the top part of the Vacuum Canister.
Connect the Hose to the inlet of the Vacuum at the rotate clockwise to lock hose
into position. For dry applications use the upper hose connection, and for wet ap-
plications use the lower connection.
Connect both Metal Tubes to the end of the Hose, and attach the appropriate at-
tachment.
Make sure the Drain Cover (21) is in place whether utilizing the Vacuum for wet or dry
applications. The Vacuum will not work properly without the Drain Cover in place.
oPeration instructions
attachments
floor brush: The Floor Brush is designed for use in cleaning large
areas, such as floors, low-pile carpets and rugs. The head of the
tool rotates a full 360° for ease of use.
crevice nozzle: The Crevice Nozzle enables the operator to
vacuum in close quarters, corners, and cracks. It also works quite
well when the blower function of the vacuum is being used.
utility brush: The Utility Brush is designed to excel at extracting
water from surfaces and in fabrics. When clean and dry, it can also
be used to vacuum furniture and carpeted surfaces.
HePa filter & dust bag
To install or remove the HEPA Filter (25). Remove the Vacuum Assembly from the
top of the Canister (19), and turn it upside down.
The HEPA Filter is the prominent cylinder at the bottom of the Vacuum Assembly.
The filter is held onto the HEPA Frame (16) by the HEPA Cover (26). A 1/4 turn will
allow the HEPA Cover to be removed or replaced.
The Dust Bag is placed over the HEPA Filter for dry applications and should be
cleaned following each use.
10.
11.
12.
13.
1.
2.
3.
floor brush
crevice nozzle
utility brush
floor brush
crevice nozzle
utility brush