Harley-Davidson CRUISER M0412 - Manual (Page 12)

M0412a-0920
16
12
ASSEMBLY F
M0412a-0920
15
• Slide an axle bushing (tube side first) onto the end of the
wheel axle. Make sure the flat end of the axle bushing fits
into the groove in the fork arm.
• Fit a .437 (large diameter) cap nut on the end of the wheel axle.
• Support the opposite end of the wheel axle and tap the .437 cap
nut with a hammer to secure it on the end of the wheel axle.
• Pull on the .437 cap nut to make sure the rear wheel assembly
is secure.
.437 (Large
Diameter)
Cap Nut
Axle Bushing
Tube Side
Wheel Axle
.437"
• Lift the pretend buckles on a saddlebag to open the saddlebag.
• Fit the tab on the back surface of the saddlebag into the notch
on one side of the rear fender.
• Insert three #8 x 3 /
4
" screws through the holes on the inside of
the saddlebag.
Note: The lower screw inserts through holes in the saddlebag
and vehicle body, and then attaches to the vehicle frame. Make
sure all three screw holes are aligned.
• Tighten the screws.
• Repeat this step to assemble the other saddlebag to the other
side of the rear fender.
Saddlebag
Tab
Notch
14
• Position the vehicle assembly so that the back is facing you.
• While holding the hex bushings in place, position the wheel
between the rear fork arms of the vehicle frame.
• Slide the wheel axle (with axle bushing) through one rear fork
arm, through the wheel (with hex bushings) and out through
the other rear fork arm. Make sure the wheel axle bushing fits
into the groove in the fork arm.
Axle
Bushing
Rear
Fork
Arm
Groove
Rear
Fork
Arm
Wheel (with
Hex Bushings)
Back View
17
Steering
Bushing
Vehicle
Frame Neck
• Position the vehicle frame so that the front faces you.
• Fit a steering bushing underneath the neck of the vehicle frame.
• Insert a #8 x
3 /
4
" screw into each end of the steering bushing
and tighten.
Front View