Harley-Davidson CRUISER M0412 - Manual (Page 24)

1
2
IMPORTANT! Use only a Power Wheels ® 12 volt lead-acid
rechargeable battery. Use of any other battery will damage
your vehicle. Make sure that you charge the battery for at
least 18 hours using the enclosed Power Wheels
® 12 volt
charger before operating your vehicle for the first time. Charge
the battery for at least 14 hours after each use of the vehicle.
Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will
void your warranty.
BATTERY INSTALLATION H
24
M0412a-0920
• Remove the seat. Press the tab at the back of the seat and lift.
• Place the Power Wheels
® 12 volt battery upright in the battery
compartment. Make sure the battery terminals face the rear
of the vehicle.
Power Wheels ®
12 Volt Battery
Battery
Compartment
TM
• Fit the battery retainer over the battery.
• Insert a screw through each end of the battery retainer and
into the screw pegs in the vehicle body. Tighten the screws.
Battery Retainer
Screw
Peg
Screw
Peg
TM
• Plug the motor harness connector into the battery. Push firmly
to make sure the connector is secure in the battery.
• Replace the seat on the vehicle.
Battery
Motor
Harness
Connector
3