HONDA 2005 CB900F - Manual (Page 7)

2005 CB900F
4
©2005 American Honda Motor Co., Inc. - All Rights Reserved
6. Remove the front shipping bracket.
Remove the bolts and front shipping bracket
from the handlebar mount.
7. Install the throttle grip.
Remove the protective wrap from the throttle
grip/switch assembly.
Slide the throttle grip/switch assembly onto
the right side of the handlebar. Move the grip
until the pin in the switch assembly drops into
the hole in the handlebar.
Close the bottom half of the switch assembly
and secure the halves using a 5 x 20 mm
screw/washer in the front hole and a
5 x 25 mm screw/washer in the rear hole.
Torque the screw/washers, starting with the
front one.
Torque: 4 N·m (0.4 kgf·m, 3 lbf-ft)
8. Install the handlebars.
Align the handlebar punch mark with the top
edge of the lower holder.
Set the upper holders onto the handlebar
with their punch marks to the front.
Attach the handlebar using four 8 x 32 mm
socket bolts. Torque the four bolts starting
with the front two.
Torque: 27 N·m (2.8 kgf·m, 20 lbf-ft)
Attach the socket bolt caps to the
handlebar bolts.
BOLTS
FRONT SHIPPING BRACKET
5 x 25 mm
SCREW/WASHER
5 x 20 mm
SCREW/WASHER
PIN
HOLE
HANDLEBAR
PUNCH MARK
BOLTS
PUNCH MARK PUNCH MARK