HONDA 2005 CB900F User Manual
Page 8
©2005 American Honda Motor Co., Inc. - All Rights Reserved
5
9. Attach the handlebar weight.
Align the tab on the handlebar weight with
the recess in the handlebar.
Insert the weight into the handlebar and
attach it with a 6 x 65 mm oval head screw.
Torque the screw.
Torque: 10 N·m (1.0 kgf·m, 7 lbf-ft)
10. Install the front brake
master cylinder.
Place the master cylinder assembly on the
handlebar. Align the edge of the assembly
with the punch mark on the handlebar.
Set the master cylinder holder, with its UP
mark facing up, on the assembly.
Attach it using two 6 x 22 mm flange bolts.
Torque the two bolts, starting with the
top one.
Torque: 12 N·m (1.2 kgf·m, 9 lbf-ft)
Connect the brake light wires to the master
cylinder terminals.
11. Install the turn signal switch.
Position the switch assembly on the
handlebar by inserting its pin into the hole in
the handlebar and aligning the end cap with
the groove in the switch assembly.
Attach the switch assembly using a 5 x 45 mm
screw/washer in the front hole and a
5 x 35 mm screw/washer in the rear hole.
Torque the screw/washers, starting with the
front one.
Torque: 4 N·m (0.4 kgf·m, 3 lbf-ft)
HANDLEBAR WEIGHT
FRONT BRAKE
MASTER CYLINDER
SWITCH
CONNECTORS
6 x 22 mm
FLANGE BOLTS
UP MARK
5 x 45 mm
SCREW/WASHER
END CAP
HOLE
PIN
5 x 35 mm
SCREW/WASHER