HONDA 2005 CB900F - Manual (Page 9)

2005 CB900F
6
©2005 American Honda Motor Co., Inc. - All Rights Reserved
12. Install the clutch lever assembly.
Position the clutch lever assembly on the left
side of the handlebar. Loosely attach it using
its holder and two 6 x 22 mm small head
flange bolts. Be sure the holder's UP mark is
facing up.
Align the split between the holder and
lever assembly with the punch mark on
the handlebar.
Torque the two bolts, starting with the top
bolt first.
Torque: 12 N·m (1.2 kgf·m, 9 lbf-ft)
Connect the clutch switch connectors to the
switch terminals.
13. Remove the motorcycle from the
crate base.
Route a sling under the steering stem. Be sure
not to trap any cables, hoses or wires
between the sling and the frame.
Route another sling through the rear wheel.
Attach the slings to a fork lift or similar lifting
device and apply just enough tension to the
slings to support the motorcycle.
Use a spreader board, if needed, to prevent
the sling from rubbing on the rear body.
UP MARK BOLTS
PUNCH MARK
CONNECTORS
SLING
SLING