Henny Penny SCD-6/8 - Manual (Page 3)

Model SCD-6/8
2-5. THERMAL SENSOR 1. Remove electrical power supplied to the unit.
REPLACEMENT
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the side panel closest to the controls.
3. Pull back insulation to expose sensor wires.
Figure 2-5 4. Using a Phillips head screwdriver, remove the mounting plate
screws and pull plate from unit (Figure 2-5).
5. Pull wire connector apart (Figure 2-6).
Figure 2-6
6. Using a flat-head screwdriver, pry the sensor from the plate
(Figure 2-7).
7. Snap a new sensor onto bracket and replace sensor in reverse
order, starting with step 5.
Figure 2-7
203 2-3